Dynatech MP-7000 Manual de servicio Pagina 54

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 53
50 9650-0801-01 Rev. A
Removing the Printer Module
Tools Required
#1 Phillips screwdriver with torque capability
Orange (wooden) stick
Setup
This procedure should be conducted on a static mat.
Wear a wrist strap to ground during the procedure.
To reinstall the printer module, reverse the steps.
Printer Disassembly
1 Place the unit screen down on the mat in a
horizontal position.
2 Open the printer housing and remove the
printer paper.
3 Remove the two (2) screws inside the
printer module in the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
4 Remove the two (2) screws on the outside
of the printer.
Note: During reassembly, torque screws to
6 in-lbs.
5 Slowly remove the printer from the unit,
being careful not to strain the cables.
Vista de pagina 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 91 92

Comentarios a estos manuales

Sin comentarios