Dynatech MP-7000 Manual de servicio Pagina 64

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 63
60 9650-0801-01 Rev. A
3 Disconnect multi-wire IBP cable with ferrite
in the area illustrated.
4 Cut the tie wrap to the IBP cable in the area
shown with the orange stick.
Note: During reassembly, secure a new tie
wrap to the IBP cable.
5 Disconnect the USB flex cable from ZIF
connector in the area illustrated.
6 Lay front end of separated unit down with
opened side facing up.
7 Disconnect the black EtCO
2
tube
connector from the air vent.
8 Remove four (4) screws in the areas
illustrated to release the silver EtCO
2
module.
Note: During reassembly, torque screws to
6 in-lbs.
multi-wire IBP cable
Vista de pagina 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 91 92

Comentarios a estos manuales

Sin comentarios